Hydraulic Power Pack 12-24V DC 9 Lt/min 3000 PSI HIGH POWER P&T / Single Acting / Double Acting

AU$1 197.00
In stock
Product Details

These are a Higher Power unit than our other Power Packs listed. These are have been designed for a large range of hydraulic purposes,eg smaller crane trucks, (Effers, Palfinger etc)or any hydraulic cylinder or motor or pump that is used intermittently, but requires a higher flow. Flow equals speed.Our lower powered power pack will lift the same tonnage, however at a slower rate. This is a 2.5Kw (280A rated) 12v, or 2.8 Kw 24v (150A rated) engine. It is capable of up to 9Lpm up to 3000psi

It is available in both either P & T (for use when you have a manual lever control valve), Single acting( when gravity brings load back down, ie power only on up cycle) in both 12 Volt DC or 24 Volt DC. Double acting enables the power pack to lift load up & down.

These are quality units, made at a leading hydraulic manufacturer.

The Single acting & double acting units come with a hand held control pendant & a 3.8 litre tank standard. You can request bigger tanks to improve oil cooling

It is important to compare the 'Duty cycle' of our powerpack vs other units.

Powerpacks are high energy consumers, so put out a lot of heat. Our units will run longer with less stress than most. This is important if it is in constant use & for longevity.

Available also in P & T, Single acting, or Double acting (see other listing)

Capable of generating up to 200 Bar (3000 PSI) Pressure.
Can be mounted Horizontally or Vertically.


Power Rating 12 Volt DC, 2.5 KW , or 24 Volts DC, 2.8 KW

  • Flow 9.0 liters Minute
  • Max Pressure up to 200 BAR (3000 PSI at reduced flow)
  • Pressure relief valve Factory set at 150 BAR
  • Discharge Ports 9/16 UNO
  • 3.7 Liter capacity Oil tank with combination filler breather level plug and separate plug.
  • Larger tank capacities also available
  • Can be mounted Horizontally as well as Vertically (Motor Up only)
  • Safety thermistors installed in motor windings to prevent overheating.
  • Duty Cycle = 25% at Low Duty, low load and pressure (600 PSI) = 100Amps Draw,
  • Allowable run time 12.5 minutes and then allowed to totally cool down.

or 150 seconds ON - 400 seconds OFF.

  • Duty Cycle = 19% at Medium duty medium load and pressure (1600 PSI) = 160 Amps Draw
  • Allowable run time 7.5 minutes and then allowed to totally cool down. or 150 seconds ON - 640 seconds OFF.
  • Duty Cycle = 7% 300 Amps High Duty High Load and pressure (3000 PSI) = 300 Amps Draw
  • Allowable run time 1.7 Minutes and then allowed to totally cool down or 150 seconds ON and 2000 seconds OFF.
  • Use ISO 48 Hydraulic Oil or ATF Fluid for this unit
  • Dimensions Length = 60 cm Width = 24 cm Height = 26 cm
  • Weight 16 KG

Use ISO 48 Hydraulic Oil or ATF Fluid for this unit

We also offer ‘Depot to Depot’ freight as a cheaper alternative for larger items. Please call or email for this freight option Please call us on 0755631982

Save this product for later